Raymond mill installation site

Before installation, plant and infrastructure should be based on the installed base of Raymond mill size chart to design, must have sufficient height and installation location. Raymond mill base should be high-standard cement, but also to be buried before being poured reinforced foundation, but I buried conduit or cable channel to go electric.

After pouring the cement foundation, you need to have 15 days of curing time, after reaching the optimum hardness begin installation Raymond mill. First gear hanging into the pit filled base, this time we must pay attention to control the height of the upper horizontal instrument calibration, and then fixed with anchor bolts tightened to note that to add rubber shock pad.

Plumbing fixtures shall be designed to position and height of the total figure Raymond mill installation shall be arbitrarily altered and heightening, in strict accordance with the angle, the slope for each pipe joints should be sealed, without leaks after tightening Raymond mill should be carried out after the test machine the parts to be installed.

Raymond machines in the production process is carried out according to the procedure prescribed, must not tamper with their own, to prevent the occurrence of some irreparable damage. Raymond machine must follow these steps when you start:

(1) starting hoist;

(2) Starting crusher finish after starting to add material crushing, so there is a certain material hopper reserve;

(3) Start grader, according to the desired product fineness speed:

(4) Starting blower. After the start finish open the inlet duct valves;

(5) FOB host, for the roller, grinding ring but more wear and avoid excessive vibration machine. Host idle time not too long that no more than two minutes. In order not to overload the host of origin, not allowed to have too much starting material in the host;

(6) start vibrating feeder, and the amplitude adjusted as required; Shutdown order to stop feeding and stop the host, stop the fan, and finally stopped grader. In order to ensure normal working Raymond machine, reducing the mill failure and improve the quality of flour, Raymond turned on the switch must be in accordance with the above order. And to always monitor the mill load, to prevent the phenomenon of blocking machine and idling.